At times the light kit in your ceiling fan halts working. Sometimes it quits utilizing the decor inside your room. Whatever your advantages for wanting to eliminate the light kit from your ceiling fan, you can do it without taking away the ceiling fan in the ceiling. This minor change is possible to your hall fan without interfering while using the way it runs. Removing the light kit in the ceiling fan also gives you the put a new one in the place.

1) Let down the breaker that supplies the electricity to the ceiling fan at the main electrical screen.

2) Remove your light kit housing in the bottom of your ceiling fan. This part will probably be attached by three and up screws, remove it to get into the wiring for that light kit.

3) Disconnect your white wires in the light kit. Locate the white wires which can be connected together in the light kit cord housing. One wire is connected to the ceiling fan plus the other is connected to the light kit. Untwist the wire nut that's holding these a pair of wires together. Place the cord nut back on to the white wire in the light kit wire housing that's permanently connected to the ceiling fan. Placing the cord nut back on to the single light wire safely addresses the bare end on the wire. Secure the wire nut to the white wire using electrical tape.

4) Disconnect your black wires in the light kit. Locate each black wires that connect together in the light kit cord housing. One wire is connected to the ceiling fan plus the other is connected to the light kit. Disconnect these two wires like you did with your white wires by means of untwisting the cord nut. Replace the cord nut onto your black wire that's permanently connected to the ceiling fan, safely covering the bare wire. Secure the wire nut to the black wire using electrical tape.

5) Get rid of the light kit in the light kit cord housing cap using pliers to clear out the nut in the threaded rod that's holding the light kit to the cap. Pull the light kit off of the cap. Plug the knockout in the light kit cap with a ½-inch knockout stopper.

6) Attach your light kit cord housing cap to the ceiling fan. Once your mild kit is stripped away from the wire housing cap it is now used to cover the light kit wire housing. Make use of the screws from step two to attach it back to the ceiling fan.

7) Turn the power on to the ceiling fan by turning on the breaker that products the electricity to the fan at the primary electrical panel. You can read this article also How to Pick a Ceiling Fan Light Kit